3.2
Remove the
2 x towers (11)
and
support
bar (12)
and remove cutouts. Add glue
where shown, and attach a balance
tower to each side of the support bar.
Make sure the engraved detail lines on
the towers faces outwards.
3.3
Add glue where shown, and slot the
balance tower assembly into the holes
of the power station base.
3.4
Cut the remainder of the DSST into four
strips and stick them to the areas shown
here on each solar panel:
Do your best to keep all the wires we used to
attach the solar panels to the SolarEngine
hidden in between the two cells.
3.5
Remove the
2x balance holders (13)
and remove cutouts. Sandwich the 3/4"
ball bearing between the two balance
holders and slide the assembly into the
notches on the bottom of the power
station. The parts will snuggle into place,
and everything will lock together.
ASSEMBLY STEPS
PCB side of
the solar
cell
Stick each solar panel onto the power
station assembly. Rest the edge of the
solar panel on the base so that the
height of each solar panel is the same.
DSST strips
(photo above and
illustration below
are 180° rotated
from the top view)
The Paris Flyer CarouSol Kit
8