Solarbotics Squid Hunting, Manual, Page: 8 / 16

7
Locate the SolarEngine and
motor assembly. Slide the pager motor
into the slot created by the top rib and
motor fin.
3.4
The wires of the pager motor should be
straddling the fin on the top rib so one wire
is on each side when the motor is fully seated.
Feed the wires of the SolarEngine
through the ring assembly. You want your
wires to exit just ahead of the middle
mounting ring.
Finish with the SolarEngine module
sitting in the middle of the ring cavity.
3.5
3.6
Seat the top rib into the top slots of
rings, making sure the two are fully
mated together.
ASSEMBLY STEPS
It’s important to keep the rectangular
mounting hole on the right side of the sub as
shown in the diagram.
Mounting
Tab Side
Mounting
Tab Side