Solar Stik PRO-VERTER S 3000, Operation And Maintenance Manual, Page: 45 / 69

| 45 December 2020 | Solar Stik
®
, Inc.
Operator and Maintenance Manual for the PRO-Verter S 3000
PRELIMINARY
PRO-Verter Status and Alarm LEDs
Figure 26. PRO-Verter S 3000 user interface
LED INDICATIONS
Status STATUS LED ALARM LED
Seen during power-on sequence
Indicates completion of power-on sequence after power
On/Off button is pressed for 2 seconds (sec)
Flash 3 times Off
Seen during power-off sequence
Indicates completion of power-off sequence after power
On/Off button is pressed for 5 s
On On
Normal charging Flash 1 time/sec Off
Equalization charging Flash 2 times/sec Off
Inverting (discharging)
Alarm beep/3 sec (default off)
On Off
Low battery alarm
Alarm beep/1 sec
On Flash 1/sec
Power saving Flash 1 time/3 sec Off
Standby Flash 1 time/5 sec Off
Fault Off On
Table 3. User Interface LED Indicators
The Status LED indicates the operating status of
the PRO-Verter; the Alarm LED indicates a fault
has occurred; specific information about the fault
is reported on the user interface LCD screen. To
clear faults see
Clearing PRO-Verter Faults. The
table below explains the meaning tied to each
state for both LEDs.