Solar Stik 20-0302204, Operator And Maintenance Manual, Page: 25 / 43

| 25 January 2020 | Solar Stik ® , Inc.
24VDC Power Hub 3500 Operator Manual
Monitoring System Batteries: Current and Historical
DEVICE LIST
Battery Monitor
Time
100% 0.0V 0.0A
Solar Charger #1
Solar Charger #2
Notifications*
Settings
>
>
>
>
>
Battery Monitor
Battery
Time
26.33 V 0.0A 0.0W
State of charge
Temperature
Starter voltage
Consumed AmpHours
Time-to-go
Relay state
Alarms
History
>
>
100%
0.01V
0.0Ah
--
Off
History Time
Deepest discharge
Average discharge
Total charge cycles
Number of full discharges
Cumulative Ah drawn
Minimum voltage
Maximum voltage
Time since last full charge
Synchronisation count
Low voltage alarms
High voltage alarms
Low starter bat. voltage alarms
Minimum starter bat. voltage
Maximum starter bat. voltage
Discharged energy
Charged energy
>
0.0Ah
0.0Ah
0.0Ah
0
0.00V
0.00V
29.98V
0s
0
0
0
--
0.00V
0.00V
0.00kWh
0.00kWh
Alarms Time
Low battery voltage
High battery voltage
Low SOC
Low starter voltage
High starter voltage
Low temperature
High temperature
Mid-point voltage
>
OK
OK
OK
OK
OK
OK
OK
OK
75 ºF
List of Battery Monitor Alarms
High voltage alarm
Low voltage alarm
High starter-voltage alarm
Low state-of-charge alarm
Low battery temperature alarm
High battery temperature alarm
Mid-voltage alarm
High charge current alarm
High discharge current alarm
Cell Imbalance alarm
Internal error alarm
Press the Menu button one time to display the device list. The window that will appear is illustrated
below. The Battery Monitor will be the first device listed. Values for the current battery SOC, DC
bus voltage, and current (amps) will appear in the fields on that line. Press the Select or Right
button to open the Battery Monitor window to display current details about the batteries connected
to the System. The temperature displayed here is the Power Hub internal temperature, not the
temperature of the System batteries. Alarms and historical data related to the System batteries are
found in the Alarms and History Menus.
As the System batteries approach a fully charged state, the charging current will approach zero (0)
amps even if the sun is shining brightly and/or the generator is running. If this occurs, check the
battery SOC to confirm that the batteries are nearing a full charge. If not approaching 100%, ensure
the PV arrays are connected and functioning properly. Charging parameters can be changed if
necessary. Please contact your FSR for assistance.