10
Accessories
23. Measuring beaker
8. Round brush
9. Angle nozzle
10. Taper nozzle
11. Fabric accessory
12. Cloth for fabrics
13. Window-cleaning accessory
14. Flexible pipe
ONLY MOD. LV1450
15. Handle
16. Extension pipes
17. Joint for window-cleaning accessory or fabric accessory and nozzles
18. Joint for floor brush
19. Floor brush
20. Cloth for paved surfaces
21. Shoulder strap
22. Accessory bag
FILLING THE RESERVOIR BEFORE USE
• Make sure that the appliance is unplugged.
• Open the lid of the “Comfortsafety” system (6), check that the “Comfortsafety” system full indicator (7) is
not red and fill it with 1 beaker (23) (Fig. 1). Remember that the water level should not exceed the
maximum mark on the beaker.
• Close the lid of the “Comfortsafety” system (6).
USER INSTRUCTIONS
• Attach the required cleaning accessory and plug in the appliance.
• The pilot light (5) will come on indicating that the appliance is plugged in.
• When the steam cleaner has the pressure required to operate , the pilot light (5) will go off indicating
that you can start to use it. This operation will take approximately 2 minutes. During use, the pilot light
will switch on and off, indicating that the steam cleaner is recovering the necessary pressure.
• Press the steam control (2) to obtain steam.
• If you want to activate the locked steam position, keep the steam button (2) pressed and press the steam
lock button (3) until it is locked in place (Fig. 2). To switch off the locked steam function, press the steam
button (2) lightly and it will unlock. We recommend that you only use the locked steam function when
you will be using the extension pipes (16).
• We recommend pressing the control (2) repeatedly for short bursts rather than just a few times for
longer periods, so as to maintain pressure in the boiler and increase the performance of the steam.
• When you finish using the steam cleaner, unplug it and wait for it to cool down before removing the
accessories.
• We recommend that you empty the water tank if you are not going to use the appliance again.
ACCESSORIES
Taper nozzle (10)
• Insert the taper nozzle (10) in the accessory base (4) by lining up the lugs on the taper nozzle with the
holes in the base (4) and turn it clockwise (Fig. 3).
