Sokkia GSR2700 ISX, Operation Manual

Page: 36 / 106

26 GSR2700 ISX Operations Manual
Chapter 3
Display Panel Operations
When the memory has over 80% space available, LED 5 (green) is
illuminated. LED 1 (red) is illuminated if the memory is almost
full. When LED 1 is illuminated, you should consider deleting or
downloading files to increase available space.
3.2.4 Timer gauge
The Timer gauge has two modes to indicate quality and
quantity of data collected for successful static data
post-processing:
• Baseline Length —The gauge will indicate occupation
by baseline length. The LEDs will show solid green.
• Elapsed Time —The gauge will indicate elapsed time
since the start of the survey. The LEDs will flash.
NOTE The Timer mode can be selected using the Timer LED field in
the GSR2700 IS/ISX Config Tool software. For more
information, see Section 1.6, Finding More Information , page 8.
3.2.4.1 Baseline length mode
When this gauge is configured to display receiver occupation by
baseline length, the LEDs will display in solid green to show the
length of the baseline that can be accurately post-processed given
the amount of raw data that has been collected (see Table 12).
If you haven’t collected enough data to process a baseline of 5
kilometers, none of the LED indicators will be illuminated.
NOTE Table 12, Timer Gauge - Baseline Length Mode , page 27
provides estimates only. Performance of the indicator depends
on quality GNSS data being observed at other receivers (no
obstructions, same satellites, low multipath, etc.). If you are
uncertain about the quality of the data collected, log data for a
longer period of time.
5 –
4 –
3 –
2 –
1 –