Softing FG-200 HSE/FF, User Manual

Page: 15 / 82

Chapter 3 - Installation
Version EN-112021-1.30.3
15
3.1.2 Mounting and dismounting
Note
Make sure the FG-200 HSE/FF Modbus is mounted in such a way that the power supply can be
easily disconnected.
Note
Depending on the installation position, the maximum ambient operating temperature may
differ. See Section Installation positions for details.
Installation and inspection
Installation and inspection must be carried out by qualified personnel only (personnel qualified
according to the German standard TRBS 1203 - Technical Regulations for Operational Safety).
The definition of terms can be found in IEC 60079-17.
Mounting
1. Hook the upper notch of the cut-out on the back of the FG-
200 HSE/FF Modbus into a 35 mm DIN rail.
2. Press the FG-200 HSE/FF Modbus down towards the rail
until it slides into place over the lip of the locking bar.
Note
Do not put stress on the system by bending or torsion.
Dismounting
1. Slide a screwdriver diagonally under the housing into the
locking bar.
2. Lever the screwdriver upwards, pull the locking bar
downwards - without tilting the screwdriver - and move the
gateway upwards off the rail.
17