69
Display
Description
Remedial action
-0-
When switched on, the
The scale automatically sets to
zero. If the scale is outside the
intended tolerance range, the
display shows -0-.
Take the weight off the scale.
Remove any dirt.
If the scale does not show zero
seconds, please contact your manu-
facturer‘s service department.
_____
Underload: In the display field
only the lower
horizontal lines.
Switch off the scale and switch it
switch on again. The zero point is
automatically reset.
-----
Overload: In the display field
only the upper horizontal lines.
The maximum weighing range
has been exceeded.
Remove part of the load from the
Remove from the scale
Err 04
Part weight too small.
Err 05
Zero setting limit exceeded or
fallen below.
Err 06
Taring with unloaded
balance and in case of overload
possible.
Err 07
Printing at underload or overload
Overload not possible.
Err 08
Switching kg/lb locked.
If the faults cannot be rectified or other error messages are displayed, please contact your
Soehnle Industrial Solutions service partner.
Display
Description
Remedial action
If the battery symbol
is permanently lit: Terminal is in
battery or rechargeable battery or
rechargeable battery operation.
When the full battery symbol
flashes:
Battery is charging.
When the empty battery symbol
flashes:
Battery is discharged.
Approx. 30 min. of operating time
remain.
Connect the unit to the mains adapter
and Charge terminal for 10 hours.
LO
Battery is empty.
Connect the unit to the mains adapter
and charge terminal for 10 hours.
Only for rechargeable battery/battery application:
10. Malfunctions - causes and elimination