Soehnle Professional 3035, Manual

Page: 102 / 124

102
The designation of the reference weight is entered by pressing the F6 key "Edit". Enter the designation with
the keypad and confirm the entry by pressing the F6 key "Accept". The article number is entered in the same
way.
6.7.13 Organizational data (identifier)
Detailed information on the organizational data can be found in chapter 5.11.
6.7.14 Settings in Setting Mode
With the parameters in setting mode, you can adapt the Counting application program to your individual
requirements.
To call up the setting mode, press the F6 Setting mode key on the Setting functions level and then press F6
Accept to call up program settings.
F6 Next calls up the program settings for the selected application program
3 Counting
Standard reference quantity Input of the standard reference quantity in pieces via numeric keypad e.g. 10
Appears in the Counting program under the F1 key e.g. Ref 10
Factory setting: 10
Minimum reference weight Enter the minimum reference weight using the numeric keypad.
The minimum reference weight applies to the total weight of the reference parts.
The basis for the calculation is the smallest digit (d) of the scale.
The factory setting is 10 digits.
Values between 1 and 50 are possible.
Example of a scale with 1 g digit:
Factory setting is 10 d = 10 g for the total weight of the reference parts.
If you reduce the factory setting to 5 d, the scale will accept 5 g as
Minimum weight for the total weight of the reference parts.
If you increase the factory setting to 20 d, the scale requires 20 g as minimum
weight for the total weight of the reference parts.
When the ADD mode is activated, the scale requests the missing parts until the
minimum reference weight is reached. If the calculated reference weight is less
than 10% of the smallest digit of the scale the error message "Error 04 Reference
weight too small" is displayed.
Optimisation of reference Input percentage value