50
Set Lengths for Interleaved 2 of 5
Parameter # L1 = 0x16, L2 = 0x17
The length of a code refers to the number of characters (i.e., human readable characters),
including check digit(s) the code contains. Lengths for I 2 of 5 may be set for any length,
one or two discrete lengths, or lengths within a specific range. To set lengths via serial
commands, see
Setting Code Lengths Via Serial Commands
on page B-7.
Note:
When setting lengths, single digit numbers must always be
preceded by a leading zero.
One Discrete Length
- Select this option to decode only those codes containing a selected
length. For example, select
I 2 of 5 One Discrete Length
, then scan
1
,
4
, to decode only
I 2 of 5 symbols containing 14 characters. Numeric bar codes begin on
page
82
. To
change the selection or cancel an incorrect entry, scan the
Cancel
bar code on
page
84
.
I 2 of 5 - One Discrete Length
Two Discrete Lengths
- Select this option to decode only those codes containing two
selected lengths. For example, select
I 2 of 5 Two Discrete Lengths
, then scan
0
,
6
,
1
,
4
,
to decode only I 2 of 5 symbols containing 6 or 14 characters. Numeric bar codes begin
on
page
82
. To change the selection or cancel an incorrect entry, scan the
Cancel
bar
code on
page
84
.
I 2 of 5 - Two Discrete Lengths