Socket DURASCAN D740, Programming Manual

Page: 5 / 122

5
Make sure the scanner is not connected to a host computer or device before scanning a
command barcode.
Factory Reset
Configures the scanner to factory defaults. The scanner powers off after scanning this barcode.
Pairing Reset
If the scanner is paired with a device, unpair it before trying to connect to a different device.
Step 1: Scan barcode (for serial number that begins 1931 and above only).
Or follow steps to manually reset scanner:
A. Power on the scanner.
B. Press and hold down the scan button.
C. Press and hold down the power button.
D. After you hear 3 beeps, release both buttons.
The scanner will unpair and automatically power off.
Step 2: Remove or forget the scanner from the Bluetooth list on the host device.
The scanner is now discoverable.
Both steps above must be done to complete the unpairing.
Resets