background image

Electrical Safety

1.  Ground fault circuit interrupter (GFCI) protection should  

be provided on the circuit(s) or outlet(s) to be used for  

the snow thrower. Receptacles are available having  

built-in GFCI protection and may be used for this  

measure of safety.

2.  To prevent electric shock, use only with an extension cord 

suitable for outdoor use, such as SW-A, SOW-A, STW-A, 

STOW-A, SJW-A, SJOW-A, SJTW-A, or SJTOW-A.

  Before use, check that the extension cord is in good 

condition. When using an extension cord, make sure to 

use one heavy enough to carry the current your product 

will draw. For lengths less than 50 ft (15 m), a No.14 AWG 

(or greater) extension cord should be used. An undersized 

cord will cause a drop in line voltage resulting in loss of 

power and overheating.

3.  To reduce the risk of electric shock, this appliance has  

a polarized plug (i.e. one blade is wider than the other).  

Use this appliance only with a polarized UL-, CSA-, or 

ETL-rated extension cord for outdoor, all-weather use.  

The appliance plug will fit into a polarized extension 

 

cord only one way.

  If the appliance plug does not fit fully into the extension 

cord, reverse the plug. If the plug still does not fit, obtain 

a correct polarized extension cord. A polarized extension 

cord will require the use of a polarized wall outlet. The 

extension cord plug will fit into the polarized wall outlet 

only one way. If the plug does not fit fully into the wall 

outlet, reverse the plug. If the plug still does not fit, 

contact a qualified electrician to install the proper wall 

outlet. Do not modify the appliance plug, extension cord 

receptacle, or extension cord plug in any way. 

4.  To prevent the appliance cord from disconnecting from 

the extension cord during operation, use the on-board 

cord restraint hook and/or make a knot with the two cords 

as shown in Table 1.

5.  Do not abuse the cord. Never pull the snow thrower 

by the cord or yank the cord to disconnect it from the 

receptacle. Keep the cord away from heat, oil, and sharp 

edges.

Personal Safety

1.  Stay alert – Watch what you are doing and use common 

sense when operating the snow thrower. Do not use the 

machine when tired, ill,

 or under the influence of drugs, 

alcohol, or medication. A moment of inattention may 

result in serious personal injury.

2.  Wear proper clothing – 

Wearing rubber boots offers 

additional protection from electric shock. Do not wear 

loose clothing or jewelry that may become caught in the 

machine. Wear protective headgear to keep hair away 

from revolving parts of the machine. Safety glasses offer 

better protection than everyday eyeglasses.

3.  Moving parts present risks – Keep your face, hair, 

clothing, hands, and feet away from moving parts. All 

guards and safety attachments must be installed properly 

before using the unit. Shut off and disconnect 

the cord 

before touching any parts other than the handles and  

the switch.

4.  Surfaces – This snow thrower is intended for use on 

paved surfaces. Do not use on gravel, stone, or other 

unpaved surfaces unless the snow thrower is adjusted for 

such surfaces according to the instructions given in this 

operator’s manual.

5.  Avoid accidental starting – Make sure the switch is in 

the off position before plugging in the unit. Do not carry 

the snow thrower with your finger on the switch. 

m

          

WARNING! 

 

m

Electric shock may cause SEVERE INJURY or 

DEATH. Heed these warnings:

•  Do not allow any part of the snow thrower to make 

contact with water while it is in operation. If the 

appliance becomes wet while turned off, wipe dry 

before starting. 

•  Use only a UL-, CSA-, or ETL-rated extension cord 

for outdoor, all-weather use, such as the Snow Joe

®

 

+ Sun Joe

®

 Power Joe SJTW-A 14-gauge 50-foot 

extension cord with lighted end (Model PJEXT50-B). 

Visit snowjoe.com to purchase this extension cord 

online or, to order by phone, call 1-866-SNOWJOE 

(1-866-766-9563).

•  Do not use an extension cord over 100 ft (30 m).
•  Do not touch the appliance or its plug with wet hands 

or while standing in water. Wearing rubber boots 

offers some protection. 

EXTENSION CORD CHART

Cord Length:

Min. Wire Gauge (A.W.G.):

50 ft (15 m)

14

100 ft (30 m)

12

(B) Connect plug and receptacle

Cord set

Appliance cord

(A) Tie cord as shown

Table 1. Method of Securing Extension Cord

2

Summary of Contents for Ultra SJ619E





















Reviews: