8
Figure 7
Chute Handle
5. Fasten the locking collar and snap into plate (see Fig.6-1, 6-2).
Note: The locking mechanism should be in back of the chute.
If you have trouble installing the discharge chute, please
visit www.snowjoe.com for a step by step assembly video.
You can also call toll free 866-Snow-Joe for live support Monday
to Friday 9 am-5pm Eastern time.
Figure 6-2
6. Loosen the knobs found on the top of the chute assembly
and pivot the upper chute up or down to the desired angle.
Tighten the knobs before operating the snow thrower.
7. Use the chute handle to position the direction you want to
throw the snow (see Fig. 7).
Note: Never lift the unit by the chute handle
Fuel Recommendation
Use automotive gasoline (unleaded or low leaded to minimize
combustion chamber deposits) with a minimum of 87 octane.
Gasoline with up to 10% ethanol or 15% MTBE (Methyl Tertiary
Butyl Ether) can be used. Do not use an oil/gasoline mixture, dirty
or E85 gasoline. Avoid getting dirt, dust, or water in the fuel tank.
!
Refuel in a well-ventilated area with the engine stopped. Do
not smoke or allow flames or sparks in the area where the
engine is refueled or where gasoline is stored.
!
Do not overfill the fuel tank. After refueling, make sure the
tank cap is closed properly and securely.
!
Be careful not to spill fuel when refueling. Spilled fuel or
fuel vapor may ignite. If any fuel is spilled, make sure the
area is dry before starting the engine.
!
Avoid gasoline contact with skin or breathing of vapor.
Figure 6-1
SJ_803_MANUAL ENG_R_Layout 1 9/2/10 2:23 PM Page 8
