.0.2-.03 in.
(0.60-0.80 mm)
Electrode
15
Belt Keeper
Hex Screws
Idler Pulley
Figure 21
Figure 22
Belt Off
Auger Pulley
Engine Pulley
1
2
3
4
Figure 20
4. Check that the spark plug washer is in good condition and
thread the spark plug in by hand to prevent cross-
threading.
5. After the spark plug is seated, tighten with a spark plug
wrench to compress the washer.
Replacing the Belt
To replace the belt:
1. Remove the belt cover by removing the five hex screws that
secure it to the frame.
2. Push down on the idler puller to release the old belt from
under the belt keeper. Remove the old belt by grasping it
from the bottom of the auger pulley and pulling outward.
To replace the belt follow these instructiona and refer to Fig. 22:
1. Push down on the idler puller.
2. Position the new belt on top of the auger pulley and under
the belt keeper.
3. Route the belt around the engine pulley
4. Push the belt over the bottom of the auger pulley.
5. Reinstall the belt cover.
SJ_803_MANUAL ENG_R_Layout 1 9/2/10 2:23 PM Page 15
