Lit. No. 78520/78521/78522, Rev. 01
7
April 1, 2019
INSTALLATION INSTRUCTIONS
6. Determine whether to use the inside or outside
angle ram holes, depending on the width of
the UTV. If the UTV width exceeds 60", attach
the angle rams to the outer blade holes. The
snowplow width is to be equal to or greater than
the width of the UTV. Align the holes in the rod
end of the angle ram with the corresponding holes
on the back of the blade.
7. Install a 1/2" x 2-7/8" clevis pin or
1/2" x 4" Grade 8 bolt (provided in the parts bag)
from the top down to attach each rod. Secure
the clevis pins with 5/32" x 1-1/2" cotter pins, and
secure the cap screws with 1/2" locknuts.
8. Install the center snow de
fl
ector using two
3/8" x 1-1/2" cap screws and 3/8" locknuts.
9. Install the blade guides using 7/16" lock washers
and 7/16" nuts for each guide.
10. With the T-frame parallel to the ground, secure the
stand with a 3/8" clevis pin and hairpin cotter.
Blade Guide
7/16" Lock Washer
7/16" Nut
Center Snow
Deflector
3/8" x 1-1/2"
Cap Screws
3/8" Locknuts
Hairpin Cotter
Stand
3/8" Clevis Pin
Summary of Contents for UTV V-Plow Series
Page 2: ......
