Lit. No. 78520/78521/78522, Rev. 01
6
April 1, 2019
INSTALLATION INSTRUCTIONS
UNPACKING
1. Set aside the blade guides and parts bag. The
vehicle electrical harnesses are located in the
mount box. The Owner's Manual is located in the
blade box. Remove the receivers by moving the
handle back toward the receivers, disengaging the
hitch pins. Remove and set aside.
2. Remove the cable ties that are holding the
assembly to the pallet.
3. Remove the fasteners and strapping that secures
the T-frame to the pallet.
T-FRAME TO BLADE ASSEMBLY
1. Remove the blade wings from the crate. Remove
the four shipping straps, then replace the cutting
edge hardware.
2. Align the hinges of each wing. Position the
T-frame assembly between the blade wings so the
holes in the T-frame are aligned with the holes in
wing hinges.
3. Insert the pivot pin from top to bottom through all
hinges as shown below.
4. Move the snowplow into a normal operating
position.
5. Remove the protective packaging from the angle
rams.
Inside Hole = 5' Width in Vee
Outer Hole = 5-1/2'
Width in Vee
Pivot Pin
Clevis
Pin
Cotter
Pin
Angle Ram
Summary of Contents for UTV V-Plow Series
Page 2: ......
