Lit. No. 78520/78521/78522, Rev. 01
10
April 1, 2019
OPERATIONAL TEST AND FINAL ADJUSTMENTS
Adjusting the Center Cutting Edges
The center cutting edge gap setter is located on the
T-frame below the pivot pin hinge.
1. Place the blade wings in the vee position and
check whether the center cutting edges touch the
center cutting edge gap setter. If they do not touch
the gap setter, adjust the center cutting edges as
follows.
2. Loosen the four 1/2" x 1-1/2" center cutting edge
carriage bolts, but do not remove them.
3. Slide the center cutting edges inward until they
contact the gap setter.
4. Tighten the center cutting edge carriage bolts
according to the torque chart.
Lubricating the Pivot Pin Hinge
Using a rubber-tipped seal-off coupler
fi
tting, apply a
good quality multipurpose grease at the
fi
ve grease
points along the center hinge of the blade.
Grease
Points
Gap Setter
1/2" x 1-1/2"
Carriage Bolts
Gap Setter
Center Cutting Edges
Summary of Contents for UTV V-Plow Series
Page 2: ......
