Lit. No. 74912, Rev. 00
8
May 1, 2020
INSTALLATION INSTRUCTIONS
T-FRAME TO BLADE ASSEMBLY
1. Remove the blade wings from the crate. Remove
the four shipping straps, then replace the cutting
edge hardware.
2. Align the hinges of each wing. Position the
T-frame assembly between the blade wings so the
holes in the T-frame are aligned with the holes in
wing hinges.
3. Insert the pivot pin from top to bottom through all
hinges as shown.
Pivot Pin
1/2" x 2-7/8"
Clevis Pins
5/32" x 1-1/2" Cotter Pins
4. Move the snowplow into a normal operating
position.
5. Remove the protective packaging from the angle
rams.
6. Align the holes in the rod end of the angle ram
with the corresponding holes on the back of the
blade.
7. Install a 1/2" x 2-7/8" clevis pin (from the shipping
bracket) from the top down to attach each rod.
Secure the clevis pins with 5/32" x 1-1/2" cotter
pins from the parts bag.
