SNOW WOLF QuattroPlow QP-102, Operation & Maintenance Manual

Page: 22 / 96

20
QuattroPlow Operation and Maintenance Manual
Operation
Attachment Inspection
Daily Inspection
NOTE: Inspect the attachment by performing a
walk around daily before and after use.
Use the following inspection checklist
as a guideline.
Check the following items every 10 hours of
operation:
• Verify that the QuattroPlow is properly
connected to the machine.
• Check that all shields and guards are in place.
• Check for damaged or leaking hydraulic hoses
or fittings. Replace if necessary.
• Check moldboard cutting edge for wear or
damage. Replace if necessary.
• Check moldboard cutting edge for wear or
damage. Replace if necessary.
• Check QP wing.
• Check that all cotter pins that retain pivot/
anchor pins are in place and not damaged or
missing.
• Check the QuattroPlow to ensure that all
components are secure and that all bolts and
nuts are thoroughly tightened.
• Check the QuattroPlow mounting hardware for
wear or damage. Inspect the pins and mount
(on the attachment) for wear or damage.
Repair or replace damaged parts if necessary.
Monthly Inspection
• Inspect the QuattroPlow for cracks, bends, or
excessive wear.
• Check wear shoes (if equipped) for wear.
• Check that all bolts are tight.
• Check moldboard cutting edge and mounting
plate for cracks or damage. Replace if
necessary.
• Check the wing cutting edge’s for cracks or
damage. Replace if necessary.
• Check hydraulic lines, connections and fittings
for hydraulic oil leaks. Repair or replace
damaged parts if necessary.
• Check for damaged or missing decals.
Replace if necessary.
• Lubricate as required.
AVOID SERIOUS INJURY OR DEATH
Before servicing the attachment:
• Always park on a flat level surface.
• Lower lift arms and place attachment flat
on the ground.
• Place all controls in NEUTRAL.
• Engage the park brake.
• Wait for all moving parts to stop.
• Stop the engine and remove the key.
SEE MACHINE’S OPERATOR’S MANUAL
FOR ADDITIONAL INFORMATION.