Snorkel A46JRT, Operator'S Manual

Page: 23 / 56

A46JRT – 0261169 19
Chapter 7 – Prestart Inspection
Engine
Remove the keeper pins and release the latches on either
side of the engine cover (refer to Figure 7.2). Remove the
engine cover to access the engine compartment.
Figure 7.2 – Engine Cover
To inspect the engine:
1. Visually inspect the engine and its components with
the engine off.
2. Inspect the cover pin and latch mechanisms to make
certain they are in good working condition to hold the
engine cover in place.
3. Make sure that the engine cover is fully closed,
latched, and that the keeper pins are securely fas-
tened before operating the machine after inspection
or service.
Oil Level
The proper oil level is between the two marks on the
dipstick.
To inspect the oil level:
1. Make sure the engine has been off for at least five
minutes before checking the oil level. This will allow
time for the oil to drain to the pan for a more accurate
oil level reading.
2. Remove the dipstick and check to see that the oil
level is between the two marks.
3. If necessary, add oil before starting the engine.
Air Intake
Deutz engines are air cooled. Visually inspect the air
intake and fan (refer to Figure 7.3) to be sure they are
free of obstructions that could stop or slow the flow of
air. Inspect the fan belt to see that it is in place and not
cracked.
Potential service and safety problems may be detected
by inspecting the aerial platform. This chapter includes
information on properly inspecting the aerial platform and
includes a prestart inspection check list at the end of the
chapter to ensure that no areas are overlooked.
Warning
The potential for an accident increases when operat-
ing an aerial platform that is damaged or malfunction-
ing. Death or serious injury could result from such
accidents. Do not operate the aerial platform if it is
damaged or malfunctioning.
Perform a prestart inspection at the beginning of each
shift, before using the aerial platform on the job. The
inspection site must have a smooth and level surface.
Operator’s Manual Holder
The manual holder is located at the front of the platform
(refer to Figure 7.1).
Figure 7.1 – Operator’s Manual Holder
To inspect the Operator’s Manual holder:
1. Make certain the Operator’s Manual holder is se-
curely fastened in place.
2. Check to see that the proper Operator’s Manual is in
the holder.
3. Check to see that the manual is complete with all
pages intact and in readable condition.
4. Make certain ANSI publication “Manual of Respon-
sibilities for Dealers, Owners, Users, Operators,
Lessors and Lessees of ANSI/SIA A92.5-2006 Boom-
Supported Elevating Work Platforms” is in the manual
holder.
Operator’s Manual Holder
Latch
Keeper Pin