Vega-MV Router Multiviewer - User Manual
Issue 1 Revision 2
Page 154
© 2017 SAM
Set up Reference Input Format and Router Outputs
Getting Started 8.5
8.5 Set up Reference Input Format and Router Outputs
1.
Show the unit’s web interface.
2.
Go to the
Module > SDI I/O Router
page.
3.
Set the
Expected Video Format
to ‘Genlock In’.
If the video inputs are of a different video standard to the reference signal, then set
Expected Video Format
to reflect the video input standard.
4.
Click the Update Layout icon,
, to push the change to the unit.
8.6 Set Up Internal Router
1.
Show the unit’s web interface.
2.
Go to the
Module > SDI I/O Router
page.
3.
Click Quick Map “
Map 1:1
” to make 1 to 1 routes in the internal routing matrix.
4.
Select the
Expected Video Format
to be the same as the reference input signal.
5.
Click the Update Layout icon,
, to push the change to the unit.
8.7 Set Up Multiviewer Output Format
1.
Show the unit’s web interface.
2.
Go to the
Module > Set Up Module > Screen
page.
3.
Select the
Resolution
of the target monitor screen for the Multiviewer Display Output.
4.
Select the
Aspect Ratio
.
5.
Click the Update Layout icon,
, to push the change to the unit.
8.8 Set Up Multiviewer Layout
1.
Show the unit’s web interface.
2.
Go to the
Layout > Load Layout
page.
3.
Select a layout which shows all inputs on one or both display outputs.
(This will be one of the pre-defined layout, listed with an asterisk suffix (*).)
4.
Load this into the web interface.
5.
Click the Update Layout icon,
, to push the layout to the unit.