Vega 30 Router User Manual
Port Configuration Template
Vega 30 RollCall Templates 7.5
Issue1 Revision 1
Page 121
© 2017 SAM
7.5.1 Port Configuration - Top Section of Template
7.5.1.1
Reset All Persistence
Click the button to reset ‘persistence’ settings (including all port settings) to their factory
default.
7.5.1.2
VFade
This comprises three VFade controls, VFadeA, VFadeB and VFadeC. These control the
‘V Fade’ settings for router outputs 1 to 12, 13 to 24, and 25 to 34 respectively.
Each control is a drop-down box.
Select the V-fade rate to reduce any audible disturbance during switching.
The setting is subjective and dependent on the audio media being switched.
•
Fast. (Default)
•
Medium.
•
Slow.
For V-fade durations, see A.9 “Audio V-Fade Rates” on page 244.
Figure 87 Port Configuration - Top Section
Reset All Persistence
VFade
Note:
Persistence Settings:
Persistence settings include:
•
All port settings.
•
Routing.
•
Names.
•
and other settings that change in normal router use.
And does NOT include:
•
Unit Information screen settings.
•
Comms Setup screen settings.
Note:
V-Fade function is enabled on an
output-by-output
basis. Use the:
•
‘V-Fade enable’ in the RollCall interface ‘Port Configuration’ template.
•
‘Quiet Switch V-Fade enable’ in the Web interface ‘Processing Control’ page.
