MV-805 IP Multiviewer User Manual
System-Setup Template
RollCall Templates 6.2
Issue1 Revision 1
Page 54
© 2018 SAM
6.2.4 RollCall Settings box
The
RollCall Settings
box sets up the unit as a RollCall device for a R connection to
SAM Orbit for multiviewer video wall control and monitoring. This includes defining R
communication parameters and specifying which network interface of the MV-805 unit to use.
Note:
“S” and “P” buttons -
After entering information in each text box, always click on the adjacent “
S”
button or press
“
return”
to
locally save
the new setting. Do this for each text box.
(Note: Clicking on the “
P”
button will return the setting to its preset default value).
“
S
” - Locally save new setting value (or press “return”).
“
P
” - Locally save default setting value.
Figure 32 RollCall Settings Box
For R connection to SAM Orbit for multiviewer control and monitoring.
Setting
Description
RollCall Network
Text box.
Enter the RollCall network address. Click the
S
button to
locally
save the new setting.
N
ote:
This is a RollCall address, not an IP network address.
See
Note 1
and
Note 2
.
RollCall Unit
Text box.
Enter the RollCall unit number.
Click the
S
button to
locally
save the new setting.
See
Note 2
.
RollCall Port
Displays the RollCall port number.
RollCall IP Port
Text box.
IP port to use for RollCall messages. Click the
S
button to
locally
save the new setting.
Note:
This can usually be left at its displayed value (2050).
Table 12 RollCall Settings
