LC2000/LC2000-IQ/LC4000/LC4000-IQ
System Setup Menus
Issue 1 Rev 6
Page 44
© 2015 SAM
7.7 Network
The Network menu provides access to the unit’s network details and setup.
7.7.1 Ethernet
The Ethernet controls enable you to view and set up all information relating to the unit’s
network connections.
•
Current IP address:
Shows the current IP address.
•
Current IP Netmask:
Shows the current netmask.
•
Current IP Gateway:
Shows the current gateway.
•
MAC Address:
Shows the unit's MAC address
•
IP Configuration:
Enables you to specify whether the unit is to use a DHCP or a
static IP address. For information about setting static and DHCP IP addresses, see
page 45.
•
IP Address:
Enables you to enter an IP address.
•
IP Gateway:
Enables you to enter a gateway address.
•
IP Netmask:
Enables you to enter a netmask address.
•
Apply IP Changes:
Applies any changes you make in the Ethernet menu.
•
IP Configuration Status:
Shows the current IP configuration.
•
Interface Status:
Shows the status of the Ethernet connection, for example, “100M
full duplex”.
Note: If Interface Status shows “down”, it means that no Ethernet connection is
detected.
