LC2000/LC2000-IQ/LC4000/LC4000-IQ
RollCall Control Panel System Setup Screens
Issue 1 Rev 6
Page 110
© 2015 SAM
10.8.2 Recall Memory
The Recall Memory button recalls the settings saved in a memory location.
To recall a memory:
1.
In the Memory Select column, choose a memory you want to recall.
2.
Click Recall Memory.
The recalled settings are applied.
10.8.3 Reset to Defaults
The Reset to Defaults button recalls the unit’s default memory settings at both system and
channel level. All controls are reset to their preset values
except
for the following:
•
Network > DHCP
•
Network > IP Configuration
•
Network > IP Gateway
•
Network > IP Netmask
•
RollCall > Unit Name.
10.8.4 Factory Reset
Factory Reset recalls the unit’s default memory settings at both system and channel level. All
controls and user memories are reset to their preset values.
The default settings for IP Configuration is to set the unit to DHCP. Any saved settings for IP
Address, IP Netmask, and IP Gateway are also lost when performing a factory reset. The unit
returns all three to their default settings, which are as follows:
•
IP Configuration: DHCP
•
IP Address: 192.168.151.1
•
IP Netmask: 255.255.255.0
•
IP Gateway: 192.168.151.200
10.8.4.1
Performing a Factory Reset
1.
From the System menu, select Memories > Factory Reset.
2.
Do one of the following to apply the changes:
•
From the Network screen, click Apply IP Changes.
•
Reboot the system.
Note:
Reset to defaults does not affect user memories.
Factory Reset clears all user memories. Make a note of any important settings before
performing a factory rest.
Note:
If performing a factory reset via a remote link, when you press Apply IP Changes, the
remote link will be lost.
