IQUDC30/IQUDC31/IQUDC32/IQUDC33
Operation Using the RollCall Control Panel
Issue 1 Rev 4
Page 75
© 2016 SAM
5.10 Audio I/O AES
The Audio I/O AES screen enables you to configure up to eight external AES connections.
5.10.1 AES 1–8
Each AES connector can be set to be either an input or an output. If set as an input, the
connectors are hard-wired to the eight AES input pairs (shown in the Input Pairs – Source list
on the Audio-Routing Ch1 screen). If set as an output, these controls select which source is
routed to the AES connector.
For each AES pair, the following list of sources is available:
•
Use as Input:
Sets AES connector to be an input.
•
Ch 1 Pair 1:
Output Pair 1 as routed on Audio Shuffle-Ch1 Routing screen.
•
Ch 1 Pair 2:
Output Pair 2 as routed on Audio Shuffle-Ch1 Routing screen.
•
Ch 1 Pair 3:
Output Pair 3 as routed on Audio Shuffle-Ch1 Routing screen.
•
Ch 1 Pair 4:
Output Pair 4 as routed on Audio Shuffle-Ch1 Routing screen.
•
Ch 1 Pair 5:
Output Pair 5 as routed on Audio Shuffle-Ch1 Routing screen.
•
Ch 1 Pair 6:
Output Pair 6 as routed on Audio Shuffle-Ch1 Routing screen.
•
Ch 1 Pair 7:
Output Pair 7 as routed on Audio Shuffle-Ch1 Routing screen.
•
Ch 1 Pair 8:
Output Pair 8 as routed on Audio Shuffle-Ch1 Routing screen.
•
Ch 2 Pair 1:
Output Pair 1 as routed on Audio Shuffle-Ch2 Routing screen.
•
Ch 2 Pair 2:
Output Pair 2 as routed on Audio Shuffle-Ch2 Routing screen.
•
Ch 2 Pair 3:
Output Pair 3 as routed on Audio Shuffle-Ch2 Routing screen.
•
Ch 2 Pair 4:
Output Pair 4 as routed on Audio Shuffle-Ch2 Routing screen.
•
Ch 2 Pair 5:
Output Pair 5 as routed on Audio Shuffle-Ch2 Routing screen.
•
Ch 2 Pair 6:
Output Pair 6 as routed on Audio Shuffle-Ch2 Routing screen.
•
Ch 2 Pair 7:
Output Pair 7 as routed on Audio Shuffle-Ch2 Routing screen.
•
Ch 2 Pair 8:
Output Pair 8 as routed on Audio Shuffle-Ch2 Routing screen.
Note:
If a pair is set as an output, it appears grayed out on the Audio Routing Ch1 screen.
