8
Introduction
Features and Specifications
Remote Operation
If needed, the Scope Module (M4) can be removed from the Diagnostic Tool, then connected to
the Diagnostic Tool with a USB cable. This increases the range of mobility for the Diagnostic Tool
while monitoring signals on the test vehicle. Use the Type A/B USB cable, which is provided with
your kit, to make the connection. For additional information see,
NOTE:
i
When used remotely, the M4 must be connected to the lower (black) USB jack on the diagnostic
tool. The upper (blue) USB jack should not be used for M4 operation.
Technical Specifications
Power Sources
The Scope Module operates on USB power (5V @ 500mA) supplied by the Diagnostic Tool.
Power is provided either through direct connection to the Diagnostic Tool, or through a USB cable
when the Scope Module is removed from the Diagnostic Tool.
Auxiliary Connector
The auxiliary connector is used for connection of the optional RPM inductive pickup and the
pressure traducer split lead adapter. For additional information contact your sales representative
and see,
Using the Scope Module Remotely
Item
Description / Specification
USB Power
5V @ 500mA
Agency Approval -
Rating
IEC 61010-1, UL Listed 61010-1 - Category 1
Width
6.3 in. (160 mm)
Height
4.6 in. (118 mm)
Depth
1.1 in. (28 mm)
Weight
0.62 lb (0.28 kg)
Operating Temperature
Range (ambient)
At 0 to 90% relative humidity (non-condensing)
32 to 113°F (0 to 45°C)
Storage Temperature
(ambient)
At 0 to 70% relative humidity (non-condensing)
–4 to 140°F (–20 to 60°C)
Environmental
Conditions
This product is intended for indoor use only
This product is rated for Pollution Degree 2 (normal conditions)
