200
Maintenance
Scan Module
17.1.5 Operating System Restore
Snap-on System Restore is a hard disk drive recovery program that allows you recover the hard
disk drive files in the event of a failure. Running the program replaces all of the C drive data with
the original factory data. Be aware, all new or modified files on the C drive will be lost.
The directional arrow icons on the Diagnostic Tool are used to navigate when performing a system
restore. Use the Enter icon to make selections.
z
To restore the operating system
1. Turn on the Diagnostic Tool.
2. Wait for the “Press Up Arrow to run Snap-on System Restore” message to display, then select
the
Up Arrow
icon.
A progress indicator displays while the program loads.
3. Select
OK
from the confirmation message.
A progress indicator displays while the files are being restored.
4. Select
OK
from the confirmation message.
The Diagnostic Tool shuts down, then reboots and the system recovery portion of the
operation begins. Follow any on-screen prompts.
The Diagnostic Tool shuts down and reboots a second time. When the VERDICT Home
screen displays, the procedure is complete and the Diagnostic Tool is ready for use.
17.2 Scan Module
This section covers how to care for your Scan Module.
17.2.1 Cleaning and Inspecting the Scan Module
When using the Scan Module, make sure to do the following:
•
Check the housing, wiring, and connectors for dirt and damage before and after each use.
•
At the end of each work day, wipe the housing, wiring, and connectors clean with a slightly
damp cloth.
IMPORTANT:
Do not use any abrasive cleansers or automotive chemicals on the Scan Module.