1
IMPORTANT SAFETY INSTRUCTIONS
WARNING
Risk of flying particles.
Over-torquing can cause breakage. Force against flex stops on flex head can cause head
breakage. An out of calibration angle wrench can cause part or tool breakage. Broken
hand tools, sockets or accessories can cause injury. Excess force can cause crowfoot or
flare nut wrench slippage.
Read
this manual completely
before using ELECTRONIC WRENCH.
To insure accuracy, work must not move in angle mode.
For personal safety and to avoid wrench damage, follow good professional tool and
fastener installation practices.
Periodic recalibration is necessary to maintain accuracy.
Wear safety goggles, user and bystanders.
Be sure all components, including all adaptors, extensions, drivers and sockets are
rated to match or exceed torque being applied.
Observe all equipment, system and manufacturer's warnings, cautions and
procedures when using this wrench.
Use correct size socket for fastener.
Do not use sockets showing wear or cracks.
Replace fasteners with rounded corners.
To avoid damaging wrench:
Never use wrench with power off. Always turn ON
wrench so applied torque is being measured.
Do not press
POWER
q
while torque is applied or while wrench is in motion.
Never use this wrench to break fasteners loose.
Do not use extensions, such as a pipe, on handle of wrench.
Check that wrench capacity matches or exceeds each application before
proceeding.
Verify calibration if dropped.
Make sure ratchet direction lever is fully engaged in correct position.
Verify calibration of wrench if you know or suspect its capacity has been exceeded.
Do not force head of flex head drives against stops.
Always pull - do not push - on wrench handle and adjust your stance to prevent a
possible fall should something give.
Do not attempt to recharge Alkaline cells.
Store wrench in dry place.
Remove batteries when storing wrench used for periods longer than 3 months.
WARNING
Electrical Shock Hazard.
Electrical shock can cause injury. Plastic handle is not insulated.
Do not use on live electrical circuits.
SAVE THESE INSTRUCTIONS
Disclaimer
Operation of TechAngle
®
Wrench is not warranted in a EU member state if operating
instructions are not in that State’s language. Contact Snap-on if a translation is needed.
Summary of Contents for TECHANGLE
Page 119: ...118 ...
