SMT 5700WOC, User Manual

Page: 153 / 162

Safety Precaution
135
Battery information and care
Never use any battery that has been damaged.
While using the phone near network station, the
power consumption is very little. Therefore, the
call and standby time depends on greatly by the
signal strength of honeycomb network and the
parameters set by network operator.
The battery charging time will depend on the
amount of electricity remaining and the type of
battery and charger used. When the operation
time (talk time and standby time) is noticeably
shorter than normal, it is time to buy a new
battery.
Only use batteries that are compatible with your
phone and only recharge your battery with a
compatible charger. If a charger is not in use,
disconnect it from the power source. Do not
leave the battery connected to a charger for more
than a week, as overcharging may shorten its life.
Improper battery use may result in a fire,
explosion or other hazard. Do not disassemble or
open, crush, bend or deform, puncture or shred
the battery.
Do not connect the anode and cathode of a
battery the wrong way round.
Do not leave the battery in places with too high
or too low temperature or the battery capacity
will be reduced and battery life will be shortened.
Always try to keep the battery at room
temperature.
Do not short-circuit the battery. This may damage
the electronic core or the protected circuit inside
the battery. Accidental short-circuiting may occur
when a metal object (coin, clip or pen) causes a
direct connection between the anode and cathode
of the battery, for example when you carry a
spare battery in a pocket or bag. Short-circuiting
the terminals may damage the battery or the
object causing the short-circuiting. Therefore,
please store the battery carefully and on its own.
Don’t burn your phone battery or treat it as