Page 9 of 17
Installing in firewall mode
This section describes how to install the appliance as a firewall. Typically, this is used in a Unified Threat Management installation.
To install the appliance as a firewall:
1. Place the appliance in a stable and secure location.
2. Connect an Ethernet cable from your network switch to port 1 of the appliance.
3. Connect an Ethernet cable from a port on the appliance to an external network, or internet connected router or firewall.
4. Using the AC power cord, connect the appliance to the power supply. The appliance boots.
Note: On initial start-up your appliance will perform a series of system configuration tasks. Please be patient while your
appliance completes this initial start-up procedure.
If the appliance does not power on and boot automatically, hold down the
key on the keypad for one second.
