www.smoothfitness.com
23
MAINTAINENCE
To apply lubricant under the walking belt
:
1. Position the walking belt so that the seam is located on top and in center of the walking board.
2. Insert the nozzle of the lubricant container under the belt
3. While lifting the side of the walking belt, position the nozzle between the walking belt and the board
approximately 15 cm (6 inches) from the front of the treadmill. Apply the silicone lubricant to the walking
board, moving from the front of the treadmill to the rear. Repeat this on the other side of the belt. Note: it is
important to get the lubricant as far to the center of the walking board as possible.
4. Allow the silicone to "set" for 1 minute before using the treadmill.
Apply lubricant from front to back.
CLEANING
:
Routine cleaning of your treadmill will extend the product's life.
•
Warning
: To prevent electrical shock, be sure the power to the treadmill is OFF and the power cord is
unplugged from the wall electrical outlet before attempting any cleaning or maintenance.
•
Important
:
DO NOT
use abrasives or solvents to clean the treadmill. To prevent damage to the computer,
keep liquids away and keep it out of direct sunlight.
•
After each workout
: Wipe off the console and other treadmill surfaces with a clean, water dampened soft
cloth to remove excess perspiration.
•
Weekly
: Use of a treadmill mat is recommended for ease of cleaning. Dirt from your shoes contacts the belt
and eventually makes it to underneath the treadmill. Vacuum underneath treadmill once a week.
Note:
when lubricating the belt, make sure the treadmill is located on a surface that can
be easily cleaned. After lubricating your treadmill running belt, clean any excess silicone
off the belt and frame
.
