6
Insert the Patient Line in the
Clamp Slot and push it back
into the slot.
15
Make patient connection.
9
Close pinch clamps above the
Heat Exchanger and below the
IV Fluid bag spikes.
2
Snap the Heat Exchanger
into Guide.
11
Hang spiked IV Fluid bags in
Pressure Chambers.
•
Choose the hook that allows the bag port
to hang freely in the indented slot at the
bottom of the chamber door.
Close the doors and secure the
latches.
1
Push the bottom end of the Heat
Exchanger firmly into #1 block.
3
Slide #2 block down firmly.
10
Remove air from IV Fluid
bags:
•
Using aeseptic technique, pierce bag
port membrane with disposable set
spike.
•
Withdraw spike, squeeze out ALL air,
and re-spike bag.
4
Move the pinch clamp connector
on the Patient Line of the Gas Vent/
Filter Assembly next to the Luer
connector. Close the pinch clamp.
7
Push door up to engage the top
hinge and then push door in to
engage the metal tab to close.
12
Prime through the Gas Vent/
Filter Assembly:
•
Open pinch clamp/s below IV Fluid bag
spike, squeeze drip chamber and prime
the line through the Gas Vent/Filter
Assembly.
•
Open remaining pinch clamp/s below IV
Fluid bag spike/s to prime additional line/s.
•
When lines are primed, close pinch
clamps, leaving one open for infusion.
When IV Fluid bag empties:
1. Move the Pressure Chamber lever to
the
–
position.
2. Close the pinch clamp below empty
IV Fluid bag.
3. Move lever on the other Pressure
Chamber to
+
position and open
pinch clamp to begin infusion.
4. Open door of de-pressurized
Chamber and replace empty IV Fluid
bag with new bag with ALL air
removed (Steps 10 & 11).
5. Alternate between Pressure
Chambers.
5
Open #3 Clamp Slot door. Press
down on the metal tab and pull door
down and away from Clamp Slot.
13
Open pinch clamp below Gas
Vent/Filter Assembly to prime the
patient line and remove all air,
and then close the roller clamp.
8
Press Gas Vent/Filter Assembly
into #4 block.
14
Press the green Power ON
button.
16
Open roller clamp on the
patient line to begin infusion.
IMPORTANT: Please refer to the Operator’s Manual supplied with the product for detailed instructions, contraindications, warnings, and cautions.
Refer to the IFU for DI-60HL Administration Set for specific priming instructions.
17
Move Pressure Chamber
lever to the
+
position.
Level 1
®
H-1200 Fast Flow Fluid Warmer
DI-Series Disposable IV Administration Set
(DI-70/DI-100/DI-300/DI-60HL)
Step-by-Step Guide
