POSYC 3303 industrial PC
Installation, use and maintenance manual - EN
Ver. 1.02
18
CAUTION
Use a cable with a suitable cross-section, sized correctly according to the through-current.
A cable with a section smaller than that required may cause fire due to overheating phenom-
ena generated by the cable itself.
To ensure compliance with the EMC 2014/30 / EU directive, the length of the cables must
not exceed a length of 30 meters.
The POSYC 3303 is a high-tech electronic device, sensitive to electrostatic discharge (ESD)
phenomena. Pay the utmost attention to prevent such phenomena, complying with the pro-
visions of the law, in order to avoid damage to the device.
24V power supply
Pin
Signal
1
+24 VDC
2
GND
3
FE (functional earth) on 6.3mm male faston adjacent to the connector
2
3
1
