User Manual
WD2145-WD1160-WD4060-WD4190
Page 19 - 85
5.2
CONTROLS - DETAILED DESCRIPTION
BUTTONS
DESCRIPTION
On/Off
The button is operational with the door opened or closed.
The button turns the device’s interface on and off, allowing its use. Hold it down for 2
seconds for both switch-on and switch-off.
Once the appliance has been switched on, the code of the selected program appears on
the display (e.g. “
Pr 03
”).
When the interface is switched off, the display shows a flashing
“OFF”
message.
When the door is open, the display shows 4 horizontal dashes and none of the other
interface buttons are active. The device is still powered up even when the interface is off.
-
/-
(only on WD4060, WD4190 series)
The buttons increase/decrease the intensity (and duration) of the drying phase.
Holding down the “
Drying–
” button selects a
separate drying program;
the display shows
the message “Pdry”.
If the cycle set has a drying phase, these buttons are enabled and the drying LED
illuminates.
If the cycle set does not include a drying phase, the buttons are not enabled and the drying
LED remains off.
These are “first touch” buttons; there is no need to hold them down.
The drying duration set is displayed as follows:
- 3 horizontal bars on the display; maximum time setting, default time
- 2 horizontal bars, medium duration
- 1 horizontal bar, short duration
Start/Stop
This button starts the selected cycle or interrupts a cycle in progress. It must be held down
for 2 seconds. Two beeps sound when a cycle is started or stopped.
The button is also used (again holding it down) to confirm the value of an appliance
parameter during modification.
Functions
Hold down:
access to the appliance setup parameters, password required. Refer to the
SETUP MODE
- “FUNCTIONS”
section for a detailed explanation.
Short press:
whenever the
Functions
button is pressed,
the display screen changes; the various screens show the parameters of the cycle selected
in combination with the LED which explains their meaning.
For a full understanding of the values shown on the display, note that they depend on the
appliance’s status:
1. Appliance in standby
2. Washing cycle running
LED
ON
DISPLAY
Meaning of LED on
1 : 16
With appliance in standby
The value is the nominal duration of the cycle. The time LED
also illuminates. The duration is guideline; it applies in test
conditions and with correct electrical connection.
With cycle running
Time left to end of current cycle
-- : 90
With appliance in standby
Maximum temperature reached in the cycle set
With cycle running
During washing: Tank temperature
During drying: inlet air temperature. (function introduced from
firmware version 4.6.xx.yy).
