Instructions for the user
122
9.5
What to do if...
The oven display is
completely off
• Check the mains power supply.
• Check whether an omnipolar switch upstream
of the oven supply line is in the “ON” position.
The oven does not heat up • Check whether it has been set in “showroom”
mode, for further details see “6.10 Secondary
menu”.
The controls do not
respond.
• Check whether it has been set in “child lock”
mode, for further details see “6.10 Secondary
menu”.
The cooking times are
longer than those indicated
in the table.
• Check whether it has been set in “PO” mode,
for further details see “6.10 Secondary menu”.
After the automatic
“pyrolysis” cleaning cycle
(only on some models) it is
not possible to select a
function.
• Verify whether the door locking device has
switched off. If it has not, the oven has a
protection device that does not allow functions
to be selected while the door locking device is
active. This is because the temperatures inside
the oven are still too high to permit any type of
cooking.
The display shows ERR 4
(on pyrolytic models only)
• The door locking device has not properly
attached to the door. This might be because the
door was accidentally opened during its
activation. Switch off the oven and switch it on
again waiting a few minutes before selecting a
new cleaning cycle.
If the door is opened during
a fan-assisted function, the
fan stops.
• This is not a fault. It is a normal operation of the
appliance, useful when cooking foods in order
to avoid excessive heat escaping. When the
door is closed, the oven will return to normal
operation.
If the problem has not been resolved or in the case of other types of fault,
contact your local technical support centre.
