Instructions for the Installer
11
4. INSTALLING THE COOKTOP
1)
Remove the upper polystyrene guard and the side guards.
2)
Remove the grids, the nylon sheet serving to protect the cooktop
during shipping and the burner crowns. These parts could make
product assembly more difficult.
3)
Connection to the gas mains may be made with a flexible metal
pipe and conforming to the provisions defined by current standard
regulations in force. USE A SOAPY SOLUTION TO CHECK FOR
PROPER TIGHTNESS.
NEVER USE A FLAME.
The following procedures must be performed to adjust the gas
supply pressure for LP operation of the cooktop:
1 Unscrew cap A on the pressure regulator
2 Turn it to the part where LP is printed
3 Re-tighten it and lock the pins in the slots provided.
4 There is an arrow printed on the back of the energy regulator.
The tip of the arrow indicates the end to be connected to the
cooktop connector.
4)
Carefully position the insulation gasket (supplied) on the external perimeter of the hole found on the top
surface (see figures below) and try to make it stick to the entire surface by applying light pressure with
your hands. Refer to the distances shown in the figure for the model to be installed, keeping in mind that
for both models the long front side has to skim the hole.
A
B
C
D
5/16”
8 mm
2 11/16”
68 mm
9/16”
15 mm
2 15/16”
75 mm