Installation
68
5. Replace the nozzle using a 7 mm socket
wrench. Install a nozzle that is the most
appropriate for the type of gas being
used.
6. After having replaced the nozzle, put the
burner back in its seat.
7. Tighten the burner fastening screws.
8. Replace the shelf in its seat.
Adjusting the minimum setting for natural
gas
Light the burner and turn it to the minimum
position. Extract the gas cock knob and turn
the adjustment screw next to the tap rod
(depending on the model) until the correct
minimum flame is achieved.
Refit the knob and verify that the burner
flame is stable. Turn the knob rapidly from
the maximum to the minimum setting: The
flame should not go out. Repeat the
operation on all gas cocks.
The tightening torque of the nozzle
must be 4 Nm.
Take care not to damage the
thermocouple or the igniter when
doing this.
