How to Wire DIN Terminal
●Connection
1. Loosen the set screw and pull out the DIN connector from the
terminal block of the solenoid.
2. Remove screw and insert screwdriver into the slit area near the
bottom of terminal block to separate block and housing.
3. Loosen the terminal screws (slotted screws) on the terminal
block, insert the core of the lead wire into the terminal, and
attach securely with the terminal screws.
4. Tighten the ground nut to secure the cable.
Use caution in wiring because it will not meet the IP65
(enclosure) standard if you use the other cable than prescribed
heavy-duty cable of size (
ø
3.5 to
ø
7).
Tighten the ground nut and set screw within the specified
range of torque.
●Change of electrical entry (Orientation)
After separating terminal block and housing, the cable entry
direction can be changed by attaching the housing in the
desired direction (4 directions in 90 increments).
∗
In the case of w/ indicator light, avoid damaging the light with
lead wire.
•
●Precautions
Plug a connector in or out vertically, never at an angle.
●Applicable cable
O.D.:
ø
3.5 to
ø
7
(Reference)
0.5 mm2 2 core and 3 core wires equivalent to JIS C 3306
●Connector part no.: VK300-82-1
●Part no. of connector with indicator light
●Circuit with indicator light
Light/Surge Voltage Suppressor
* The light comes with the DIN connector.
Precautions on connection of 24 V or more DC
Grommet type should be connected as following; Red lead wire
for (+) side, Black lead wire for (
–
) side respectively.
With the DIN terminal, connect the positive (+) side to the
connector
’
s no. 1 terminal, and the negative (
–
) side to the no.
2 terminal. [Refer to the marks on the terminal board.]
∗
For 12 VDC or below, there is no positive (+) or negative (
–
)
directionality.
Rated
voltage
Voltage
symbol
Part no.
100 VAC
100V
VK300-82-2-01
110 VAC
110V
VK300-82-2-03
200 VAC
200V
VK300-82-2-02
220 VAC
220V
VK300-82-2-04
240 VAC
240V
VK300-82-2-07
6 VDC
6V
VK300-82-4-51
12 VDC
12V
VK300-82-4-06
24 VDC
24VD
VK300-82-3-05
48 VDC
48VD
VK300-82-3-53
VK300/3000 Series
Specific Product Precautions 1
Be sure to read this before handling the products.
Caution
Caution
- 8 -
VK300
∗∗
-OMH0002-C
