- 8 -
VFR6000-OMA0001-B
Lead Wire Connection
Plug-in type (With terminal block)
•
If you remove the junction cover (1) on the sub-plate, you will
see the plug-in terminal block (2) attached to the inside of
sub-plate.
•
Terminal block assembly is wired like the following figure.
Connect it to each power supply side.
•
Can be used as either “+COM” or “-COM”.
•
Applicable terminal:
1.25-4
,
1.25-4M
DIN terminal block type
Male pin terminal of DIN terminal block of solenoid valves are
wired as shown below. Connect to corresponding terminal on
the connector.
Can be used as either “+COM”, “-COM”
Applicable cable:
Cross section of the wire: 0.5 to 1.5mm
2
Cable O.D.:
φ
8 to
φ
10mm
Applicable terminal:
1.25Y-3L
,
1.25-3.5S
,
1.25-4M
Terminal block type
Remove cover (1), over terminal block (2) attached to the
inside of body. Connect with corresponding power side. For a
style with light and surge voltage suppressor, straightly pull out
the light and surge voltage suppressor substrate (3) and then
connect them.
Applicable terminal:
1.25-3.5M, 1.25-3L, 1.25-3M
Position
Model
Left
Center
Right
VFR610
□
A side
COM
VFR620
□
A side
COM
B side
3
VFR640
□
5
A side
COM
B side
Caution
(1)
(3)
(2)
A side
B side
A side
terminal block
B side
terminal block
(1)
(2)
VFR6000 Series
Specific Product Precautions 1
Be sure to read before handling.
Ground
Terminal No.
Internal w iring
1
Sol. A side
2
Sol. B side
3
COM
Ground