IGMP S
NOOPING
C
OMMANDS
3-119
ip igmp snooping vlan mrouter
Use this command to statically configure a multicast router port. Use the
no
form to remove the configuration.
Syntax
ip igmp snooping vlan
vlan-id
mrouter
interface
no ip igmp snooping vlan
vlan-id
mrouter
interface
•
vlan-id
- VLAN ID (Range: 1-4094)
•
interface
•
ethernet
unit
/
port
-
unit
- This is device 1.
-
port
- Port number.
•
port-channel
channel-id
(Range: 1-6)
Default Setting
No static multicast router ports are configured.
Command Mode
Global Configuration
Command Usage
Depending on your network connections, IGMP snooping may not
always be able to locate the IGMP querier. Therefore, if the IGMP
querier is a known multicast router/switch connected over the network
to an interface (port or trunk) on your switch, you can manually
configure that interface to join all the current multicast groups.
Example
The following shows how to configure port 11 as a multicast router port
within VLAN 1:
Console(config)#ip igmp snooping vlan 1 mrouter ethernet 1/11
Console(config)#
Summary of Contents for TigerSwitch SMC8624T
