IP C
OMMANDS
3-51
ip address
Use this command to set the IP address for this device. Use the
no
form to
restore the default IP address.
Syntax
ip address
{
ip-address netmask
|
bootp
|
dhcp
}
no ip address
•
ip-address
- IP address
•
netmask
- Network mask for the associated IP subnet. This mask
identifies the host address bits used for routing to specific subnets.
•
bootp
- Obtains IP address from BOOTP.
•
dhcp
- Obtains IP address from DHCP.
Default Setting
IP address: 0.0.0.0
Netmask: 255.0.0.0
Command Mode
Interface Configuration (VLAN)
Command Usage
• You must assign an IP address to this device to gain management
access over the network. You can manually configure a specific IP
address, or direct the device to obtain an address from a BOOTP or
DHCP server. Valid IP addresses consist of four numbers, 0 to 255,
ip
default-gateway
Defines the default gateway through which an
in-band management station can reach this
device
GC
3-53
show ip interface Displays the IP settings for this device
PE
3-54
show ip redirects Displays the default gateway configured for
this device
PE
3-55
ping
Sends ICMP echo request packets to another
node on the network
NE,
PE
3-55
Command
Function
Mode Page
Summary of Contents for TigerSwitch SMC8624T
