S
WITCH
M
ANAGEMENT
1-4
In-Band Connections
Prior to accessing the management module via a network
connection, you must first configure it with a valid IP address,
subnet mask, and default gateway using an out-of-band
connection or the BOOTP protocol.
After configuring the switch’s IP parameters, you can access the
on-board configuration program from anywhere within the
attached network. The on-board configuration program can be
accessed using Telnet from any computer attached to the network.
The switch can also be managed by any computer using a Web
browser (Internet Explorer 4.0, or Netscape Navigator 4.0 or
above), or from a network computer using network management
software such as EliteView.
Notes: 1.
By default BOOTP is disabled. To enable BOOTP, see
“IP Configuration” on page 2-12.
2.
Use the Network Configuration menu to specify the
maximum number of simultaneous Telnet sessions that
are supported by the system (up to four).
3.
The on-board program only provides access to basic
configuration functions. To access the full range of
SNMP management functions, you must use SNMP-
based network management software, such as SMC’s
free EliteView software.
Summary of Contents for TigerSwitch SMC6948L2
