Steps to self-configure
SMC ATA
1
Sign up for Owtalk at
http://www.owtalk.com
to get your self-
configuration information for SMC ATA.
Plug the power cord and connect the WAN port on the back of the ATA
to your cable/ADSL modem, router, or broadband Internet connection.
The factory default network setting of most of the ATA is set as DHCP
mode, i.e. the device obtains the IP address automatically from the net-
work. Follow the steps below if your ATA is in DHCP mode. Otherwise
please refer to the device user manual on how to configure your device
to connect to a LAN or Internet under Static IP or PPPoE mode.
Connect your traditional landline phone to the ATA.
2
3
4
Overview
This guide shows how to configure SMCWTVG Analog Telephone Adaptor
(ATA) so you can use the Owtalk service. But first you must be an Owtalk
subscriber.
SMC ATA can be available in preconfigured mode, labeled as Owtalk
Preconfigured on the surface of the packaging box. Under the preconfigured
mode, all Owtalk SIP account information are pre-programmed, you don’t
need to go through the following procedures. Please refer to Appendix A on
how to activate an Owtalk preconfigured device.
