Chapter 3
| AP Chassis
How to Mount the Unit
– 25 –
How to Mount the Unit
The AP can be mounted in the following ways using the included mounting
bracket:
◆
To a 1.5 to 6 inch diameter pole
The AP’s mounting bracket has two main parts. One part that can be secured to a
pole using two steel-band clamps, and another part that attaches directly to the AP.
The two parts link together and allow the tilt angle of the unit to be adjusted for
antenna alignment.
How to Pole Mount
Perform the following steps to mount the unit to a 1.5 to 6 inch diameter pole or
tube using the mounting bracket:
1.
Using the two included steel-band clamps, thread them through the slats
provided in the pole-mount part of the bracket.
2.
Place the pole-mount part of the bracket against the pole and tighten the steel-
band clamps until it is secure.
Figure 11: Attach Bracket to Pole
3.
Attach the square mounting plate to the AP with the supplied screws.
Pole Mount Bracket Part
Securing Screws, Nut and Bolt
Steel-Band Clamps
2
1
3
1
3
2
