Description of Hardware
1-3
1
1000BASE-T/SFP Ports
These are combination Gigabit RJ-45 ports with shared Small Form Factor
Pluggable (SFP) transceiver slots. If an SFP transceiver (purchased separately) is
installed in a slot and has a valid link on the port, the associated RJ-45 port is
disabled.
The 1000BASE-T RJ-45 ports support automatic MDI/MDI-X operation, so you can
use straight-through cables for all network connections to PCs or servers, or to other
switches or hubs. (See “1000BASE-T Pin Assignments” on page B-3.)
Port and System Status LEDs
The switch includes a display panel for key system and port indications that simplify
installation and network troubleshooting. The LEDs, which are located on the front
panel for easy viewing, are shown below and described in the following tables.
Figure 1-2 Port LEDs
Table 1-1 Port Status LEDs
LED
Condition
Status
Fast Ethernet Ports (Ports 1-8)
(Link/Activity)
On/Flashing
Amber
Port has established a valid 10 Mbps network connection.
Flashing indicates activity.
On/Flashing
Green
Port has established a valid 100 Mbps network connection.
Flashing indicates activity.
Off
There is no valid link on the port.
Gigabit Ethernet Ports (Ports 9-10)
(Link/Activity)
On/Flashing
Amber
Port has established a valid 10/100 Mbps network connection.
Flashing indicates activity.
On/Flashing
Green
Port has established a valid 1000 Mbps network connection.
Flashing indicates activity.
Off
There is no valid link on the port.
Port Status LEDs
System Status LEDs
Summary of Contents for SMC TigerSwitch 10/100 SMC6110L2
