SMC Networks SJ2000 Series Operation Manual Download

Page: 14 / 17

- 13 -

SJ2000-OMM0001

Connector Assembly for Manifolds (for Junction Common)

Using the connector assembly (for junction common) for solenoid
valves installed in the manifold reduces the labor involved in
wiring work because common wiring for all solenoid valves is
integrated into a single wire.

Single solenoid Double solenoid,

3 position type, 4 position type

SJ3000-46-SC-

⃞

SJ3000-46-DC-

⃞

Lead wire length

For single solenoid: SJ3000-46-SC-

⃞

For double solenoid

For 3 position type : SJ3000-46-DC-

⃞

For 4 position type

How to Order

Indicate  the  part  no.  of  the  connector  assembly  for  the  manifold
and solenoid valve.
If the arrangement is complicated, please specify them by means
of the manifold specification sheet.
Note 1) Applications like connectors not wired to a valve is not possible.
Note  2)  For  the  solenoid  valve,  please  designate  “No  connector

(MOZ)” for the connector type.

Note 3) Connector assembly with lead wire for place where the

signals are transmitted to the common wiring. (Only the
valves of first station and/or last station of manifold are
compatible to connector with lead wire for common.)

(Example)

SS5J3-60-04U

------- 1set

∗

SJ3160N-5MOZ ----- 2sets

∗

SJ3260N-5MOZ ----- 2sets

∗

SJ3000-46-S --------- 1set (Connector assembly for single solenoid)

∗

SJ3000-46-SC ------- 1set (Connector assembly for single solenoid)

(for junction common)

∗

SJ3000-46-DC ------- 2sets (Connector assembly for double solenoid)

(for junction common)

The asterisk denotes the symbol for assembly. Prefix it to the

part nos. of the solenoid valve, etc.

Wiring Instructions for Connector Assembly (for Junction Common)

If only connector assembly (for junction common) is ordered,
please wire according to the instructions in the diagram below.
For details on socket mounting, please refer to “How to Use Plug
Connector” on the back page 12.

Wire connection instructions
1. Strip 6.5 to 7.5 mm from the tip of the lead wire.
2. Loosen the terminal screws (slotted screws) of the

power  supply  terminal  connectors,  plug  the  core
wire  of  the  lead  wire  into  the  square  holes  of  the
connector,  tighten  terminal  screws  at  the  proper
torque,  and  fasten  them  securely.  (Gently  pull  the
lead wire and check that it is fastened.)

Precautions

- To remove the power supply terminal connector, pull it upward

as is. When mounting, push it in until it makes a snapping noise.

- When connecting wire, be careful because using lead wire that

is outside of compatible lead wire ranges, or that are tightened
to anything other than the proper torque, creates a risk of
defective contact and other problems.

Connector Assembly Part No.(for Junction Common)

How to Wire to PC Wiring System Compliant Power Supply Terminal

For junction common

Connector assembly
SJ3000-46-S

Connector assembly
(for junction common)
SJ3000-46-SC

Double solenoid
SJ3260N-5MOZ

Common wiring

SJ2000/3000 Series

Specific Product Precautions 6

Be sure to read before handling.

Common wiring

Socket