![background image](http://html1.mh-extra.com/html/smc-networks/protocessor-fpc-ed2/protocessor-fpc-ed2_startup-manual_1299373036.webp)
Additional Information
VorTek ProtoCessor Start-up Guide
36
9.4
LED Diagnostics for Communications Between ProtoCessor and Devices
See the diagram below for ProtoCessor FPC-ED2 LED Locations.
Tag
Description
Run
The Run LED will start flashing 20 seconds after power indicating normal operation. The
Heat
Beat
LED has the same functionality but flashes more rapidly.
Sys/
Config
Error
The Sys/Config Error LED will go on solid 15 seconds after power up. It will turn off after 5
seconds. A steady red light will indicate there is a system error on ProtoCessor. If this occurs,
immediately report the related “system error” shown in the error screen of the FS-GUI
interface to support for evaluation.
Node Offline
The Node Offline LED will turn on and stay solid if there is no communication with the device.
RX
The RX LED will flash when a message is received on the field port.
TX
The TX LED will flash when a message is sent on the field port.
PWR
The power light should show steady green when connected to a functioning power source.
Figure 38: Diagnostic LEDs