-24-
5.3.1 Positioning Mode
①
To prevent accidental impact at the end of the stroke, operate the actuator at a low speed initially. When
changing speed or movement, increase the values whilst checking operation (Change motor speed,
acceleration/deceleration time, movement distance values if required).
②
Actuator positioning operates using [Forward (CCW)] and [Reverse (CW)].
(Check wiring and parameters if operation cannot be performed correctly).
When performing positioning operation in the setup software, the rotation direction of the actuator does not
change if you change the setting of parameter PA14 (Rotation direction selection).
The
actuator moves in
the direction of [Forward (CCW)] button and [Reverse (CW)] button.
③
Check the command impulse unit (electronic gear enabled).
The electronic gear duty set to PA06/PA07 will be enabled.
④
If the “stroke-end (LSP, LSN)” signal is not configured as ON, an alarm may occur.
(When
checked, the “stroke-end (LSP, LSN)” will be automatically turned ON only when this window
is open.)
Item
Setting range
Unit
Description
Motor speed
0 to Allowed Speed for
each actuator
r/min
Set the command speed of the servo motor for execution of positioning
(Motor rotations/min).
Acceleration/de
celeration time
0 to 50000
ms
Set the time until the servo motor reaches/stops to the rated speed
(3000 r/min)
Move distance
0 to 99999999
pulse
Sets movement distance.
①
③
④
②
