-36-
No. JXC
※
-OMT0002-C
5.3 Setting of EtherNet/IP
TM
using RSLogix5000
TM
Method to connect the JXC93 to the Rockwell Automation EtherNet/IP
TM
module (master) is shown below.
Refer to the Operation Manual of the
RSLogix5000
TM
for the detailed operation.
: This figure shows the display of Rockwell Automation software, RSLogix5000
TM
.
•Select [EtherNet/IP
TM
module] in [I/O Configuration] folder, then select [New Module].
•The [Select Module] screen is displayed. Select [ETHERNET-MODULE Generic Ethernet Module], then
select [Create].
